OLD - FET-5.27.6-snapshot available

[Liviu Lalescu]

I have made available this new snapshot. From the ChangeLog:

   - Updated the sources to gcc-5.2.1 (but the Windows version still uses MinGW 4.9.2).
   - Minor improvements for timetable and statistics printing, by Volker Dirr (improved margins handling).

The link, as usual, on http://lalescu.ro/liviu/fet/download/test/

Volker, please tell the users what to test about the printing margins.

[Volker Dirr]

In previous versions the margin handling was bugged if you compiled with Qt 5.x.x

So following test would be fine:
Generate a timetable and then go to FET -> timetable -> print

Please check enter different margin settings and check if they are correct as soon you preview and/or print.
Especially if you lower the margin very much (or even down to 0).

If you compile with Qt 5 you should get a warning report if your margins setting for your printer is to low. Please increase then up to the minimum value of your printer and check if the margins are set correct. (In the past the margin was to high, even you set a small value)

Please let me know your results (success and failure). Please also report your used printer (pdf or real printer), your OS (Windows, Linux, Mac) and your used Qt Version.

[Bobby Wise]

I have always had my margins set on 0 especially for the All Activities.

When I print with the new snapshot it warns me that I should increase my margins to 6.27l, 6.35r, 6.27t, 6.35b.

But I can only set them to either 6 or 7, so I set them to 7.

The timetable printout is fine. Looks good.

Thanks

My printer is TinyPDF